Showing all 7 results
The Impulse Valve Operator (IVO) provides a means to activate a Fike Impulse Valve container via an electric signal from a Fike control panel. The IVO can also be manually activated by removing the safety cotter pin and depressing the red strike button.
The Impulse Releasing Module (P/N 10-2748) provides the primary interface between the supervised releasing circuit(s) of a Fike fire suppression system and the Impulse Valve Operator (IVO); which is used to release the fi re suppressant agent from an impulse valve container. The IRM is equipped with three capacitors that receive a constant charging current from the releasing circuit of the control panel. When fully charged, the module is capable of fi ring a single IVO. Upon circuit activation, the output circuit reverses its output voltage polarity, causing the energy in the capacitors to be released to the Impulse Valve Operator. Each IRM is equipped with a red LED to provide positive indication that the module is in the active (release) state.
The Fire Watch FW-MPS-1T-KL is a heavy-duty, commercial-grade manual fire alarm pull station designed with a single primary purpose: to provide occupants with a secure, highly reliable way to manually initiate a building-wide fire alarm, emergency evacuation, or the release of special hazard suppression systems (such as FM-200, Novec 1230, or CO2)
The FW1810-13 is a microprocessor-based, 3-zone conventional fire alarm control panel engineered specifically for fixed fire suppression and clean agent extinguishant releasing systems.
The FW1823-10 is a heavy-duty, surface-mounted extinguishing abort switch designed for critical fire protection and life safety systems. Its primary function is to allow personnel to safely delay or halt the discharge of automated gaseous fire suppression systems (such as FM-200, Novec 1230, or CO2) in the event of a false alarm or if people are still evacuating the protected hazard area.
The FW1832-10 PLUS FW-XT Manual Extinguishant Disablement Switch (Red) is a safety disconnect switch designed for gaseous fire suppression releasing systems. It is primarily used to isolate the fire suppression agent from accidental discharge during routine system testing, inspections, or maintenance.
The cylinder supervisory pressure switch is intended to detect a fall in pressure in the Kidde Engineered System cylinder. The cylinder supervisory pressure switch can be wired for either normally open or normally closed operation, depending on installation requirements. This cylinder supervisory pressure switch can be installed on Kidde Engineered System cylinders, 10 lb. through 900 lb. size.